We need to sort out our console setup so it's in a mergable state for upstream, and functional for us.
A console is the 'back end' of `printk()`. Its job is to get characters from the kernel to the user. There are several kinds of console supported:
- 8250 serial
- MUX serial
- STI graphics
- possibly other
The Emerald serial console is not yet supported. Linux has some other fun consoles we haven't played with yet like the parallel port console and netconsole.
The PDC console is available at all times on all PA-RISC hardware. We use it as an early debug console and as a system panic console. It's not suited for use as a general purpose console as it has limited facilities for console input.
In order to initialise the GSC 8250 console, we need to find the GSC 8250 serial port which happens quite late in boot. The same is true for the MUX console. The Diva 8250 console is similar, though it is a PCI device. SuperIO 8250 console gets initialised quite early as we know it is accessible at `0x3f8`. The graphics consoles also happen a bit later during boot.
In order for us to get output as soon as possible, we should register the PDC console ASAP. As other consoles come up, they are supposed to take over using the `CON_BOOT` mechanism (this has not been merged upstream yet).
We export the `con_start` and `log_end` variables from `printk.c` so we avoid printing stuff twice. Maybe we could use the PdcStableStorage driver to figure out which device was the real console and clear that device's `CON_PRINTBUFFER` flag?
`pdc_console_die()` appears to be an unused function.